L2R - 4.5.9 - My character disappears

When attempting to test run my created character for the first time, I run into the issue of the screen loading, but the character disappears almost immediately after loading. All other tile sets remain. Only character disappears.

I keep retracing my steps in tutorials to see if I set something wrong, but no luck. No error message, so I’m clueless at this point.

Any help is appreciated.
 

dale_coop

Moderator
Staff member
The character disappears...? Do you have the same issue when you place the player on another screen?
Make sure your Player's "solid object reaction" is not set to "destroy me". Make sure you haven't set any Player's Action Step to end with "destroy me".

Maybe you set hurt/death collision tiles on your screen?
You might have deviate from the tutorial. I really suggest you to check again, pausing, comparing the settings...
 

Jonny

Well-known member
Did you check mark persistent in the characters object information
I was thinking something like that too or animations/action states. Depends if it's just shown for a split second as screen loads or longer.
 
The character disappears...? Do you have the same issue when you place the player on another screen?
Make sure your Player's "solid object reaction" is not set to "destroy me". Make sure you haven't set any Player's Action Step to end with "destroy me".

Maybe you set hurt/death collision tiles on your screen?
You might have deviate from the tutorial. I really suggest you to check again, pausing, comparing the settings...
I had left ‘Destroy Me’ on an idle animation state by mistake when trying to figure out working in the hurt animation. Just set it back to loop and we are good to go. Thank you so much.
 
Top Bottom